SDI-104 Operator's Manual
Version 2008

[Search Manual] [Table of Contents] [FAQ] [Go to Previous] [Go to Next]


Changing GVAR Sounder Dataset Names

Perform steps 1-2 below to change GVAR sounder dataset names. See the previous page to change GVAR imager dataset names.

1. To change ADDE names associated with particular datasets, edit the /data/opt/etc/RESOLV.SRV file. The following is an example of a sounder dataset defined in this file. Notice that all fields are comma delimited.

N1=GVAR,N2=SNDR,TYPE=IMAGE,RT=N,K=AREA,R1=1001,R2=1048,C=GOES sounder AREAs,

Where:

N1

is the ADDE group name

N2

is the ADDE descriptor name

TYPE

is the data type

RT is the real-time data flag (used mostly with grid and point datasets)

K

is the data format or kind

R1

is the beginning AREA number in the range

R2

is the ending AREA number in the range; this number should always be greater than or equal to R1

C

is the comment field displayed with the DSINFO command

2. Change the values of AREA1 and AREA2 in the /data/opt/etc/rc.GVAR file to match R1 and R2 in /data/opt/etc/RESOLV.SRV.


[Search Manual] [Table of Contents] [FAQ] [Go to Previous] [Go to Next]