SDI Operator's Manual
Version 2005

[Search Manual] [Table of Contents] [FAQ] [Go to Previous] [Go to Next]

Initial Inspection

1. Remove the components from their shipping containers and inspect them for signs of shipping damage. Contact SSEC for further instructions if damage is discovered.

Occasionally, SSEC's proprietary PCI interface card (shown in the picture below) becomes partially unseated during shipment. If this happens, you will get the following error message on your console when you power up the SDI.

Open error on /dev/jmb no such device or address

Therefore, as a precautionary measure, SSEC recommends that you remove the computer's outer case, reseat the interface card, and reinstall the outer case.

[Search Manual] [Table of Contents] [FAQ] [Go to Previous] [Go to Next]